5V DC to DC power converter

3.3V DC to DC power converter

12V DC to DC power converter

Processor power pod – 48V DC to DC converter power pod – One required for each processor

Power supply Y cable for the processor power pod

DVD-ROM drive ATA IDE cable – One connector at each end

LS-120 Superdrive data cable

Internal SCSI cable (twisted pair) – 68-pin high density connectors on each end, 12.7cm (5in) long

Server management cable – 60-pin ribbon cable 63.5cm (25in)

172mm fan power cable – Services both fans

120mm hot-swap fan power cable

Internal power cable

Front control panel cable

External SCSI cable (twisted pair) – 68-pin high density internal end and a 68-pin very high density external connector on the other end

Hot-plug interface cable for the hot-plug PCI board – 40-pin, 40.6cm (16in) long

AC inlet cable (left side) – Provides power cord recepticle on the back of the chassis

AC inlet cable (right side) – Provides power cord recepticle on the back of the chassis

Front bezel

172mm hot-swap fan assembly

120mm hot-swap fan assembly

Rack mount rail kit

Field rack mount kit for mounting in 19in wide Rack System/E

Factory rack mount kit

Rocker switch – Plastic hot-plug switch on the back of the server – Activates the PCI slot and holds the card in place

I/O baseboard cover – Transparent plastic cover for the I/O baseboard

Front display panel board – Has status LEDs and buttons

2 button PS/2 serial mouse (Quartz Gray) – Has attached 6ft cable with 6-pin mini-din connector

Processor thermal dummy – Must be installed in an empty processor slot for proper cooling

LS-120 Superdisk drive assembly – Reads 120MB LS-120 disks and 1.44MB floppy disks – Includes the drive mounted on a tray with connector board

DVD-ROM drive assembly – Includes the drive mounted on a tray with connector board

36GB Ultra160 SCSI hot-swap hard drive assembly – Includes one 7200 RPM Ultra160 LVD SE SCA SCSI hard drive (Quantum Atlas V), mounted on low profile hot-swap tray

36GB Ultra3 SCSI hot-swap hard drive assembly – Includes one 7200 RPM hard drive mounted on hot-swap tray

1024MB ECC DIMM high density SyncDRAM memory upgrade kit – Includes four 256MB DIMM modules

512MB ECC SDRAM DIMM memory module – Must be installed in sets of four

2048MB ECC high density SyncDRAM memory upgrade kit – Includes four 512MB DIMM modules

1.0GB ECC SDRAM DIMM memory module – Must be installed in sets of four

4096MB ECC DIMM high density SyncDRAM memory upgrade kit – Includes four 1024MB DIMM modules

HP RX4610 LS-120 Superdrive connector board – Has IDE cable and power connectors on one side and drive connector on the other side

HP RX4610 Hot-swap SCSI backplane – Has two SCA connectors for hot-swap hard drives and a connector for the front panel cable – Hot-swap SCSI backplane – Mounts on the back of the hot-swap bay – Has two SCA connectors for hot-swap hard drives and a connec

HP RX 4610 DVD-ROM drive connector board – Has IDE and power connectors

HP RX4610 Hot-plug PCI board

HP RX4610 Processor board – Has two processor and power pod connectors on each side

HP RX4610 Power distribution board (T-dock) – Has 68-pin SCSI connector and power supply connectors

HP RX4610 Legacy I/O board – Has two internal IDE device connectors and external parallel, USB, keyboard and mouse, and two serial connectors

HP RX4610 I/O baseboard – Has 10 PCI slots (eight slots are 66MHz/64-bit hot plug and two slots are 33MHz/64-bit non-hot plug) – I/O baseboard – Has 10 PCI slots (eight slots are 66MHz/64-bit hot plug and two slots are 33MHz/64-bit non-hot plug) – Mounts

HP RX4610 Memory board – Has 32 DIMM slots

LAN adapter – 1000Base-SX PCI Gigabit Ethernet LAN adapter – Supports all PCI bus configurations

LAN adapter – 1000Base-T PCI Gigabit Ethernet LAN adapter – Supports all PCI bus configurations

Dual port PCI Ultra2 low voltage differential SCSI adapter – Has two external very high density 68 pin connectors and two internal high density 68 pin connectors

Dual port PCI Ultra2 low voltage differential SCSI adapter – Has two external very high density 68 pin connectors and two internal high density 68 pin connectors

1Gbps Tachyon TL PCI 2x Fiber Channel (FC) adapter – Single channel, short wave – Has SC connectors

1Gbps Tachyon TL PCI 2x Fiber Channel (FC) adapter – Single channel, short wave – Has SC connectors

Dual port PCI Fast Wide High Voltage Differential SCSI-3 adapter – Has two external very high density 68-pin connectors and two internal high density 68-pin connectors – For HP-UX operating system

LAN Adapter – 10/100Base-TX PCI ethernet LAN adapter

PCI 10Base-T/100Base-TX LAN board – LAN Adapter – PCI 10/100TX LAN Board for NetServer

Hot-swap redundant power supply – 100/240VAC autorange, 50/60Hz, 700/800W

Intel Itanium processor upgrade – 733MHz (2MB L3 cache)

Intel Itanium processor – 800MHz (Merced, 266MHz front side bus, 4MB Level-3 cache)

Intel Itanium processor – 733MHz (Merced, 266MHz front side bus, 2MB Level-3 cache)

Intel Itanium processor upgrade – 800MHz (4MB L3 cache)