PS/2 ‘Windows’ keyboard assembly (Silver and Carbonite Black) – Has attached 1.8M (6.0ft) cable with 6-pin (Violet) mini-DIN connector (USA)

‘Windows’ keyboard assembly (Quartz Gray, 105 key) – Has attached 1.8M cable with 6-pin (Violet) mini DIN connector (Option ABF, European-French) – Replacement for the C1405B, C1405C, and D4950B Keyboards

Ribbon cable with two self adhesive cable clamps and installation instructions – 8-pin (F) connector marked ‘NetServer’ to 8-pin (F) connector marked ‘Remote Assistant’ – 1.0m (39in) cable folded to be 63.5cm (25in) long – From Remote Assistant board to c

Ribbon cable assembly – 3-pin (F) connector to 3-pin (F) connector – 30cm (11.8in) long – I2C bus cable assembly – From hot-swap backplane boards to system (mother) board (two used)

Fast Wide SCSI ribbon cable – Cable is marked ‘Internal SCSI cable C22-90 ohm’ – Has one 68-pin (M) connector marked ‘To motherboard or PCI board’ and one 68-pin (M) connector marked ‘To SCSI mass storage device’ – 76.7cm (30.2in) long – Cable C22 – From

SCSI ribbon cable (C14) – Fast Wide (Ultra) cable marked ‘Int. SCSI bridge cable C14-90 ohm’ – 68-pin (M) connector marked ‘Top’ to 68-pin (M) connector marked ‘Bottom’ – 23.6cm (9.3in) long – Between the two hot-swap backplane boards (configuration depen

Fast Wide SCSI ribbon cable (C23) – Cable marked ‘External SCSI port cable C23-90 ohm’ – 68-pin (M) connector marked ‘To system board’ to high density 68-pin (F) connector with latch clips for the rear panel – 51.8cm (20.4in) long – From one of the proces

Floppy drive ribbon cable – 34-pin (F) connector marked ‘to system board’ to a 34-pin (F) old-style edge connector and a 34-pin (F) new-style connector marked ‘to 3.5 inch flexible disk drive’ – 61.9cm (24.4in) long

SCSI-2 90 ohm ribbon cable with termination (C31) – Cable is marked ‘Int. SCSI extension cable C31-90 ohm’ – 50-pin (F) connector marked ‘To array back plane’ and three 50-pin (F) connectors marked ‘To unterminated SCSI drive’ – 48.3cm (19in) l – From CD-

Ribbon cable for one IDE drive – 40-pin (F) connector to 40-pin (F) connector – 51cm (20in) long

Bezel assembly – Has cut outs for switches and LED activity lights – Plastic cover over the control panel PC board

Hard drive tray bezel (Flint Gray) – For 3.5-inch hard drives

Fan assembly – With housing – Mounts to the rear panel in the upper slot (above the power supply assembly)

Tubeaxial fan – Mounts to the front panel (Two used)

SCSI adapter (68-pin (F) to 50-pin (M)) – Used in some configurations for the CD-ROM drive and/or another Single-Ended SCSI drive (Narrow 8-bit to Fast Wide 16-bit)

Heat sink retainer clip – Retainer clip – Holds the heat sink on the Processor IC

Heat sink retainer clip – Retainer clip – Holds the heat sink on the Processor IC for HP LD pro 6:180

Chassis cover – Includes front, top and both sides

Locking cover (Flint Gray) – Attaches to the front of the ‘Hot Swap’ drive trays

5.25-inch filler panel (Quartz Gray) – For empty 5.25-inch drive bays above the Hot-Swap drive bay

Hot Swap drive filler panel (Flint Gray) – For empty Hot-Swap drive slots

PS/2 two-button serial mouse (Quartz Gray) – Has attached 6ft cable with 6-pin mini-DIN connector – (Part of C3751B)

2 button PS/2 serial mouse (Quartz Gray) – Has attached 6ft cable with 6-pin mini-din connector

SCSI-2 CD-ROM drive (Flint Gray) – 32X CD-ROM read – Has loading tray – Replacement for the 4X CD-ROM (Model D2992B) and 12X CD-ROM drives

4/8GB SureStore DAT 8i Single-Ended Narrow SCSI-2 DAT tape drive

4/8GB external SureStore DAT 8e Single-Ended Narrow SCSI-2 DAT tape drive

12/24GB external SureStore DAT 24e Single-Ended Narrow SCSI-2 DAT tape drive

6×12/24GB external SureStore DAT 24×6e Single-Ended Narrow SCSI-2 six slot magazine autoloader DAT tape drive

6×12/24GB external SureStore DAT 24×6e Single-Ended Narrow SCSI-2 six slot magazine autoloader DAT tape drive

20/40GB external SureStore DLT 40e Single-Ended Narrow SCSI-2 DLT tape drive

70GB SureStore DLT 70e Single-Ended Wide SCSI-2 external DLT drive

6×12/24GB SureStore DAT 24×6i Single-Ended Narrow SCSI-2 internal autoloader DDS-3 (DAT) tape drive

80GB SureStore DLT80E Low Voltage Differential SCSI external DLT drive

1.44MB, 3.5-inch floppy drive (Flint Gray) – 1/3 height – (Part of D2035A/B)

2.0GB SCSI-2 hard drive – 5,400 RPM, 3.5-inch form factor

4.0GB SCSI-2 hard drive – 5,400 RPM, 3.5-inch form factor

2.1GB hot-swap hard drive module (Flint Gray)

2.1GB hot-swap Ultra SCSI hard drive module (Quartz Gray)

4.2GB hot-swap Ultra SCSI hard drive module – 7,200 RPM

9.1GB hot-swap Ultra SCSI-2 hard drive module (Quartz Gray)

4.2GB hot-swap Ultra Wide SCSI hard drive module – 10,000 RPM

4.2GB SCSI-2 hard drive – 7,200 RPM, 3.5-inch form factor

18.2GB hot-swap Ultra Wide SCSI hard drive module – 7,200 RPM

9.1GB hot-swap Ultra Wide SCSI hard drive module – 10,000 RPM, SCA 80-pin connector

12/24GB SureStore DAT 24i Single-Ended Narrow SCSI-2 DAT drive

80GB SureStore DLT80E Low Voltage Differential SCSI external DLT drive

32MB, 60nS, 72-bit EDO (Extended Data Output) DIMM memory module – (D4295A) – for HP LD Pro

64MB, 60nS, 72-bit EDO (Extended Data Output) DIMM memory module – (D4296A)- for HP LD Pro

128MB, 60nS, 72-bit EDO (Extended Data Output) DIMM memory module – (D4297A) – for HP LD Pro NetServer

HP LD Pro Remote Assistant PC Board Assembly (Canada/US) (D2968C) – with on-board Modem – When Upgrading from a D2968A/B to D2968C also Order Firmware/Software Upgrade Kit

HP LD Pro NetServer Remote Assistant Assy (for Outside of Canada/US) (D2967C) – without on-board Modem – When Upgrading from a D2967A/B to D2967C also Order Firmware/Software Upgrade Kit

HP LD Pro NetServer Remote Assistant Board (for Outside USA and Canada) (D2969C) – EISA Intelligent Remote Management Board with Onboard NiCad Battery, Processor, & Modem (Does NOT Include the LAM)

HP LD Pro 6/180 NetServer Processor board – Has two processor sockets, two VRM sockets, and four DIMM sockets – Processor Board (Small Horizontal Board) – Has Two Processor IC Sockets, Two VRM Sockets, and Four DIMM Sockets

HP LD Pro NetServer System (Mother) Board – with Super VGA Video, Ultra SCSI Controller, IDE Controller – Large Vertical Board in Center of Chassis

HP LD Pro Hot Swap’ Backplane Board – for Three ‘Hot Swap’ Drives – Mounts in the the Rear of the ‘Hot Swap’ Drive Cage

HP LD Pro Processor Board (Small Horizontal Board) – Has One Processor IC Socket – Does NOT Include the Processor IC

Autoranging power supply – 100-240VAC input, 350 watts – For worldwide use

Autoranging power supply – 100-240VAC input, 350 watts – For worldwide use

EISA 32-Bit LAN Interface Board – has Two RJ-45 Connectors – One 10M bits/s (10Base-T) and One 100M bits/s (100VG/802.12) (P/O J2577A, 1/6 of J3007A, 1/24 of J3008A)

PCI LAN Interface Board – Has RJ-45 Connector for 10Base-T or 100Base-TX Ethernet (P/O J3171A, 1/6 of J3172A, 1/24 of J3173A)

Dual Channel Fast Wide SCSI Disk Array Controller Board – (P/O C3610A) – Plugs into a PCI Board Slot on the System (Mother) Board

Remote assistant board – Intelligent EISA based remote management board with onboard nickel cadmium (NiCd) battery, processor, and modem (Canada and USA)

Remote Assistant Board (for Outside the USA and Canada) – Intelligent EISA Based Remote Management Board with Onboard NiCad Battery, Processor, Modem, and Option Dependant LAM

32-bit PCI LAN interface board – RJ-45 connectors – Supports both EtherTwist 10Base-T and 100VG/802.12 – (J2585B, part of J3009B, part of of J3010B)

- PCI 32-Bit LAN Interface Board – has RJ-45 Connector – Supports Both Ethertwist (10BASE-T) & 100VG/802.12 (J2585B, 1/6 of J3009B, 1/24 of J3010B)

Remote Assistant Board (for Outside of Canada/USA) – Intelligent EISA Based Remote Management Board with Onboard NiCad Battery and Processor – Does NOT Include a Modem

PCI LAN Interface Board – Has RJ-45 Connector for 10Base-T or 100Base-TX Ethernet (P/O J3171A, 1/6 of J3172A, 1/24 of J3173A)

Intel Pentium Pro processor – 200MHz (P6, 256KB Level-2 cache) – Does not include heat sink for HP LD Pro 6/180

Intel Pentium Pro processor – 200MHz (P6, 256KB Level-2 cache) – Does not include heat sink

Intel Pentium Pro processor – 180MHz (P6, 256KB Level-2 cache) – Does not include heat sink