Floppy drive ribbon cable – 34 pin (F) connector marked ‘To Floppy This Side Up’ to 34 pin (F) connector – 31.2cm (12.3 inches) long

Fast Wide SCSI ribbon cable – Has three 68-pin (M) connectors – 59.4cm (23.4in) long – From the hot-swap drive bay backplane board to Fast Wide SCSI to HSC adapter board

SCSI ribbon cable kit – Includes a cable clamp and a terminated SCSI cable with five 50-pin (F) connectors – 87.6cm (34.5in) long – Between the multimedia drive bay and the system/core I/O board

1.44MB Single-Ended SCSI-2 floppy drive

Chassis assembly – Includes the internal metal chassis and exterior side and top panels

Front bezel assembly – Front panel with power switch cover and multimedia/hard disk drive door – For desk side configuration

Front bezel assembly – Front panel with power switch cover and multimedia/hard disk drive door – For rack mounted configuration

Fan (Blower) assembly for hot swap drive bay

Tubeaxial fan assembly – One Mounts on the rear panel (center) and the other on the front panel (below display) (Two used)

Rack mount kit – For mounting a D-class server in a 1.1M or 1.6M cabinet

Power switch assembly – Includes cable – Mounts next to the display assembly

Add-on color graphics board – With eight bit planes for 2D imaging – Plugs into an HSC bus slot

Add-on color graphics board – With eight bit planes for 2D imaging – Plugs into an HSC bus slot

1.2GB Single-Ended SCSI QIC tape drive

12GB Single-Ended SCSI DDS-3 tape (DAT) drive

Narrow Single-Ended SCSI-2 slot load DVD-ROM drive – 6X DVD-ROM read, 32X CD-ROM read (Pioneer DVD-303/304) – Has headphone jack and volume control – Replacement for 2X CD-ROM (A3184A) and 4X CD-ROM (A4325A) – Mounts multimedia drive tray

2GB Single-Ended SCSI-2 hard drive – 3.5-inch form factor

2GB ‘hot swap’ Differential Fast Wide SCSI-2 hard drive module

1GB hot-swap Differential Fast Wide SCSI disk drive module

2GB Differential Fast Wide SCSI hard drive

1GB Single-Ended SCSI-2 hard drive – 5,400 RPM, 3.5-inch form factor

4GB ‘hot swap’ Differential Fast Wide SCSI-2 hard drive module

4GB Differential Fast Wide SCSI disk drive

1.44MB Single-Ended SCSI-2 floppy drive with Flint Gray bezel

12GB/24GB Single-Ended SCSI-2 DDS-3 (DAT) tape drive – 5.25-inch form factor

4GB/8GB Single-Ended SCSI-2 DDS-2 tape (DAT) drive

4GB/8GB Single-Ended SCSI-2 DDS-2 (DAT) tape drive – 5.25-inch form factor

4GB/8GB Single-Ended SCSI DDS-2 tape (DAT) drive

4.0GB Single-Ended SCSI DDS-2 tape (DAT) drive – 5.25-inch form factor

16MB, 72-pin ECC DIMM memory module for HP9000 D210

64MB, 72-pin ECC DIMM memory module for HP9000 D210

32MB ECC memory upgrade kit – Includes two 16MB SIMM modules

128MB ECC memory upgrade kit – Includes two 64MB SIMM modules

64MB ECC memory upgrade kit – Includes two 32MB DIMM modules

32MB, 72-pin ECC DIMM memory module for HP9000 D210

HP9000 D210 System/Core I/O Board – Large Vertical Board on the Right Side – Includes I/O Ports, Connectors for the Processor and Remote Management Boards, Plus 4 EISA Slots and 4 HSC Slots

HP9000 D210 Processor/memory board (with one 100MHz PCXL processor)

HP9000 D210 Remote Management (HSC Access Port) Board (P/O A3342A) – Plugs into HSC Slot ‘3’ on the System/Core I/O Board

HP9000 D210 1280 × 1024 2D 8-plane color graphics board – 1280 X 1024 2D 8-Plane Color Graphics Board (P/O A4077A) – Plugs into an HSC Bus Slot

Fast Wide Differential SCSI-2 GSC/HSC interface board – (Part of A4107A)

64 Port RS-232 Direct Connect MUX System Board (P/O J2483A) – Plugs into an EISA Bus Slot

PSI Board – Provides SNA/X.25 LAN Connection (P/O J2159A) – Plugs into an EISA Bus Slot

EISA LAN host adapter board – Transfer rate up to 10Mbps, has a 15-pin AUI connector, and a ThinLAN (BNC) connector – Plugs into an EISA bus slot – For the 9000 series 700 computers – (Part of 25567B)

EISA LAN host adapter board – Transfer rate up to 10Mbps, has a 15-pin AUI connector, and a ThinLAN (BNC) connector – Plugs into an EISA bus slot – For the 9000 series 700 computers

Fast Single Ended SCSI-2 Host Bus Adapter Board (P/O A2679A) – Plugs into an EISA Bus Slot

Fast/wide SCSI interface board – Plugs into an HSC bus slot

Token Ring (IEEE 802.5 network) interface board – Plugs into an EISA bus slot – (Part of J2165A)

Token ring (IEEE 802.5 networks) interface board – Plugs into an EISA bus slot

8 Port RS-232 Direct Connect MUX System Board (P/O J2482A) – Plugs into an EISA Bus Slot

8 port RS-232 direct connect MUX system board – Plugs into an EISA bus slot

64 port RS-232 direct connect MUX system board – Plugs into an EISA bus slot

High speed X.25 board – Provides line speed up to 1.5 Mbps – Plugs into an EISA bus slot

Switching power supply (Astec SA451-3505-011) – 90-140VAC input, 60Hz – Three DC outputs, 450 watts – Mounts in bottom rear of chassis