Audio cable assembly – For CD-ROM, CD-RW, or DVD-ROM – 4-pin (F) connector to 4-pin (F) connector – 44.8cm (17.6 inches) long – Connects between the CD-RW or DVD-ROM drive and the system processor board

Management processor M-cable

Data cable – For IDE CD-ROM/DVD drive – Connects between the CD-ROM/DVD drive and the system processor board

Data cable – For IDE CD-ROM/DVD drive

Hard drive power cable

Y-cable assembly for super-80mm fan – 6-wire (three per connector) fan cable

Y-cable assembly for 80mm fan – 12-wire (three per connector) fan cable

Flex cable – For the management processor card

SCSI cable A-channel – Has one connector at each end

SCSI cable B-channel – Has one connector at each end

Power supply interface cable (module) assembly – Includes the dual power supply interface connector, the low voltage cables, and the two internal power cables terminated with line filter/power recptacle assemblies

Power supply interface cable (module) assembly – Includes the dual power supply interface connector, the low voltage cables, and the two internal power cables terminated with line filter/power recptacle assemblies

Deskside front bezel assembly (Flint Gray)

Right side bezel (Graphite) – For rack mount configuration

Left side bezel with rack latch – For rack mount configuration

Super 80mm tubeaxial fan

Thin 80mm fan – For use in tower configuration

Standard 80mm fan

80mm dual fan

Thin 80mm fan

CPU/Chassis fan

Cable management arm – Mounts on the rear of the rack cabinet – Folding arm that guides the interconnecting cables when the computer slides in and out of the cabinet (prevents them from being pinched)

Rackmount kit – For converting the tower configuration to a rack configuration – Includes the horizontal bezel, rack latches, rack fans, rails, cable management arm, C14 power cord, hardware, and instructions

ECI cover plate – Gray metal plate approximately 1.0-inches wide by 6.75-inches long

Side cover (metallic alloy) – For deskside configuration

Side cover (metallic alloy) – For deskside configuration

Main cover (Carbon Black) – Metal cover with blue-colored release handle

Deskside top cover

Cover kit (unpainted) – Includes top cover and two side covers

USB 3-button scrolling mouse (Carbon Black) – Has 2.9m (10ft) cable with type (A) USB connector

1000Base-SX Gigabit Ethernet network interface adapter board – Has one duplex fiber optic connector, requires one 64-bit PCI slot – For HP-UX operating system

36GB hot-plug Ultra320 Low Voltage Differential (LVD) SCSI hard drive – 15,000 RPM, low profile

Slimline DVD-ROM drive (Gray) – 8X DVD-ROM read, 24X CD-ROM read

Slimline DVD-ROM/CD-RW drive (Gray) – 12X CD-R write, 8X CD-RW re-write, 24X CD-ROM read, 8X DVD-ROM read

Slimline DVD-ROM/CD-RW combination drive (Carbon Black) – 12X CD-R write, 8X CD-RW re-write, 24X read CD-ROM, 8X read DVD-ROM

146GB hot-plug Ultra320 Low Voltage Differential (LVD) SCSI hard drive (Carbon Black and Port) – 10,000 RPM, 3.5-inch form factor, 1.0-inch high

146GB hot-plug Ultra320 Low Voltage Differential (LVD) SCSI hard drive (Carbon Black and Port) – 10,000 RPM, 3.5-inch form factor, 1.0-inch high

Slimline DVD-ROM drive (Carbon Black) – 8X read DVD-ROM, 24X read CD-ROM

73GB hot-plug Ultra320 Wide Low Voltage Differential (LVD) SCSI hard drive (Carbon Black) – 15,000 RPM, 3.5-inch form factor, 1.0-inch high, 80-pin SCA connector

73GB hot-plug Ultra320 Wide Low Voltage Differential (LVD) SCSI hard drive (Carbon Black) – 15,000 RPM, 3.5-inch form factor, 1.0-inch high, 80-pin SCA connector

36GB hot-plug Ultra320 Low Voltage Differential (LVD) SCSI hard drive – 15,000 RPM, low profile

1.0GB DDR-SDRAM memory upgrade kit – Includes two 512MB, 266MHz, PC2100, non-ECC DDR-SDRAM DIMM memory modules

1.0GB, 266MHz, PC2100, non-ECC DDR-SDRAM DIMM memory module for HP9000 RP3410

2.0GB, 266MHz, PC2100, non-ECC DDR-SDRAM DIMM memory module for HP9000 RP3410

256MB, 266MHz, PC2100, non-ECC DDR-SDRAM DIMM memory module for HP9000 RP3410

512MB, 266MHz, PC2100, non-ECC DDR-SDRAM DIMM memory module for HP9000 RP3410

1.0GB 266MHz, PC2100, non-ECC DDR-SDRAM DIMM memory module for HP9000 RP3410

512MB DDR-SDRAM memory upgrade kit – Includes two 256MB, 266MHz, PC2100, non-ECC DDR-SDRAM DIMM memory modules

2.0GB DDR-SDRAM memory upgrade kit – Includes two 1.0GB, 266MHz, PC2100, non-ECC DDR-SDRAM DIMM memory modules

4GB Chip Spare PC2100 DDR-SDRAM memory quad (four 1GB)

HP9000 RP3410 System processor board

HP9000 RP3410 Management processor board – For controlling the system console, reset and power management functions – Includes SIO (remote, console and UPS), VGA and LAN connectors

HP9000 RP3410 PCI backplane/riser board – Has four PCI slots

HP9000 RP3410 SCSI backplane board – Has three connectors for hot-swap hard drives

Dual channel Fast Wide Differential SCSI adapter board – Has two 68-pin very high density external connectors, and two 68-pin high density internal connectors – For HP-UX operating system – (Part of A5159B)

Dual channel Fast Wide Differential SCSI adapter board – Has two 68-pin very high density external connectors, and two 68-pin high density internal connectors – For HP-UX operating system

100Base-TX LAN four port host adapter board (Supports all PCI bus configurations) – Has four RJ-45 connectors – Require one 64-bit PCI slot – For HP-UX operating system

1000Base-T Gigabit Ethernet network interface adapter board – Has one RJ-45 connector, requires one 64-bit PCI slot – (Part of A6825A, A8685A, and A7061A)

Single channel Ultra160 LVD SCSI adapter board – Compliant with SCSI SPI-3, supports up to 15 devices – Has one 68-pin very high density external connector, and one 68-pin high density internal connector – For HP-UX operating system

Dual channel Ultra160 LVD SCSI adapter board – Compliant with SCSI SPI-3, supports up to 30 devices – Has two 68-pin very high density external connectors, and two 68-pin high density internal connectors – For HP-UX operating system

Dual channel Ultra160 LVD SCSI adapter board – Compliant with SCSI SPI-3, supports up to 30 devices – Has two 68-pin very high density external connectors, and two 68-pin high density internal connectors – For HP-UX operating system

Management processor board – For controlling the system console, reset and power management functions – Includes SIO (remote, console and UPS), VGA and LAN connectors – NOT supported in tower configurations

1000Base-T Gigabit Ethernet network interface adapter board – Has one RJ-45 connector – Requires one PCI slot – For HP-UX operating system

1000Base-TX LAN four port host adapter board – Supports all PCI bus configurations – Has four RJ-45 connectors – Requires one PCI slot – For HP-UX operating system

1000Base-TX LAN four port host adapter board – Supports all PCI bus configurations – Has four RJ-45 connectors – Requires one PCI slot – For HP-UX operating system

Single channel Ultra160 LVD SCSI adapter board – Compliant with SCSI SPI-3, supports up to 15 devices – Has one 68-pin very high density external connector, and one 68-pin high density internal connector – For HP-UX operating system

Processor power supply (or module) – DC to DC converter module with power supply cable (12V DC in, 1.5V DC at 100A nominal output)

Hot-swap redundant power supply – 650W

Hot-swap redundant power supply – 650W

Hot-swap redundant power supply – 650W

HP PA-RISC processor – 800MHz PA-RISC 8800 dual core with 1.5MB cache – Includes attached heat sink with fan

HP PA-RISC processor upgrade kit – Includes one 800MHz PA-RISC 8800 dual core processor and attached heat sink with fan

HP PA-RISC processor – 900MHz PA-RISC 8800 dual core with 3MB cache – Includes attached heat sink with fan

HP PA-RISC processor upgrade kit – Includes one 1.0GHz PA-RISC 8800 dual core processor and attached heat sink with fan