PS/2 ‘Windows’ keyboard assembly (Silver and Carbonite Black) – Has attached 1.8M (6.0ft) cable with 6-pin (Violet) mini-DIN connector (USA)

SCSI interface cable with thumbscrews on both ends – Highly flexible 68-pin ultra high density (M) to 68-pin high density (M) – 90 ohms – 2.5m (8.2ft) long

Wide SCSI cable kit – Internal cable connected to controller board – Contains one cable for NetServer LCII and one cable for NetServer E-series – From D5025A controller board to internal drives

CD-ROM drive ribbon cable – From IDE CD-ROM drive to secondary IDE connector on the system board

Floppy drive ribbon cable – 34-pin (F) connector marked ‘to system board’ to 34-pin (F) connector – 26.7cm (10.5in) long – From floppy drive to FDD connector on the system processor board

Power supply wire harness – Has connectors marked ‘to board’, ‘BP1’, ‘BP2’, ‘BP3’, ‘P1’, ‘P2’, ‘P3’, ‘P4’, ‘P5’, and ‘P6’, – Overall length is 48.3cm (19in) – To system processor board and all drives

NetServer E60 external SCSI port cable – Includes one SCSI cable to enable an external SCSI port

Ultra wide SCSI-2 cable kit – Includes a cable clamp, a terminated ribbon cable with four high density 68-pin (M) connectors and one high density 68-pin (F) to 50-pin (F) adapter – Cable length is 1.0m (3.3ft)

Chassis assembly – Includes internal metal chassis and the exterior cover assembly (U-shaped)

Front bezel (plastic) – For use with the E60 and E800 only

Tubeaxial fan – For cooling the processors and other components – Mounts on the inside rear of the chassis assembly

HP rack mount kit for NetServer E60, E200, and E800 – Includes pair of rails, plastic bezel trim, mounting hardware, and installation instructions

4-port Console Switch (Quartz Gray) – Connect up to four computers to a single monitor, keyboard, and mouse – Includes connecting cables

ATI Rage II AGP Graphics Board with 4MB SDRAM – Plugs Into the AGP Slot on the System Processor Board

Airflow guide – Directs air to the processors for cooling – Mounts in front of the fan

24GB external SureStore DAT 24e Single-Ended Narrow SCSI-2 DDS-3 DAT tape drive

NetServer Storage System/6 – External cabinet which can hold up to two half-height non-hot-swap Fast SCSI-2 drives and up to six hot-swap drive modules – Includes cabinet with 6 bays, 2 common tray shelves, dual SCSI backplane, and redundant power s

8GB SureStore DAT 8i Single-Ended Narrow SCSI-2 DDS-2 DAT tape drive

8GB external SureStore DAT 8e Single-Ended Narrow SCSI-2 DDS-2 DAT tape drive

24GB internal SureStore DAT 24i Single-Ended Narrow SCSI-2 DDS-3 DAT tape drive (Flint)

24GB external SureStore DAT 24e Single-Ended Narrow SCSI-2 DDS-3 DAT tape drive

6×12/24GB external SureStore DAT 24×6e Single-Ended Narrow SCSI-2 six slot magazine autoloader DAT tape drive

20/40GB external SureStore DLT 40e Single-Ended Narrow SCSI-2 DLT tape drive

SureStore T20i Single-Ended Narrow SCSI-2 Travan tape drive – Use this part number for replacing a defective tape drive in a NetServer product ONLY

10/20GB SureStore T20e Single-Ended Narrow SCSI-2 external Travan TR-5 tape drive – Includes power supply, cables, tape, and software

1.44MB, 3.5-inch floppy drive (Flint Gray) – 1/3 height – (Part of D2035A/B)

4.2GB Wide Single-Ended SCSI hard drive – 7,200 RPM

9.1GB Ultra Wide SCSI hard drive module – 7,200 RPM

9.1GB Ultra Wide SCSI hard drive – 10,000 RPM, 3.5-inch form factor

18.2GB Wide Single-Ended SCSI hard drive – 7,200 RPM

18.2GB Ultra Wide SCSI hard drive – 7,200 RPM, 3.5-inch form factor

18.2GB Ultra3 Wide SCSI LVD hard drive module – 10,000 RPM, 3.5-inch form factor, 1.0-inch high (Seagate ST318404LW)

9GB Ultra3 SCSI hard drive – 7,200 RPM, 3.5-inch form factor, 1.0-inch high

9GB Ultra3 SCSI hard drive module – 10000 RPM, 3.5in form factor, low profile

18GB Ultra3 SCSI hard drive – 7,200 RPM, 3.5-inch form factor, 1.0-inch high – Comes mounted on a drive tray

10/20GB SureStore T20i Single-Ended Narrow SCSI-2 internal Travan TR-5 tape drive – Includes tape and software

9.1GB Ultra Wide SCSI hard drive module – 7,200 RPM

64MB SIMM memory module for NetRAID 3Si disk array controller – (D7132A) for HP E60 NetServer

128MB, 100MHz ECC SDRAM DIMM memory module for HP E60 NetServer

256MB, 100MHz, unbuffered ECC SDRAM DIMM memory module – (D7157A) for HP E60 NetServer

64MB, 100MHz ECC SDRAM DIMM memory module for HP E60 NetServer

HP E60 NetServer Terminator board – Used in secondary processor socket for a system with only one processor

HP E60 NetServer System Processor Board – has Integrated Dual Channel Adaptec 7985 Ultra/Wide SCSI Controller, Five PCI and One PCI/ISA Card Slots and an Intel 10/100Base-TX Network Controller

NetRAID-1Si One-Channel Disk Array Controller – PCI Board with One Internal 68 Pin High Density and One External 68 Pin Ultra High Density SCSI Connector (P/O D2140A)

Wide SCSI Host Adapter Board (D5025A) – Installed in PCI Socket on System Backplane Board

PCI Wide SCSI host adapter board – Wide SCSI Host Adapter Board – Installed in PCI Socket on System Backplane Board – May Need Cables D5968A and D6001A

NetRAID-3si three-channel disk array controller – PCI board with three internal 68 pin high density and three external 68 pin high density Ultra wide SCSI connectors

Gigabit LAN adapter – PCI-X 10/100/1000TX 3Com LAN card – (3Com 3C996-T)

LAN Adapter – PCI 10/100TX LAN Board for NetServer

Intel Pentium II processor – 400MHz (Deschutes, 100MHz front side bus, 512KB Level-2 cache, SECC-2, Slot 1) – Includes heat sink

Intel Pentium II processor upgrade – Includes one 400MHz (Deschutes, 512KB Level-2 cache, Slot 1) processor

Intel Pentium II processor – 450MHz (Deschutes, 100MHz front side bus, 512KB Level-2 cache, Slot 1, ECC) – Includes heat sink

Intel Pentium II processor – 450MHz (Deschutes, 100MHz front side bus, 512KB Level-2 cache, Slot 1, ECC) – Includes heat sink for HP E60 PII/450

Intel Pentium II processor upgrade – Includes one 450MHz (Deschutes, 512KB Level-2 cache, Slot 1) processor for HP E60 PII/450

Intel Pentium III processor – 500MHz (Katmai, 100MHz front side bus, 512KB Level-2 cache, Slot 1) – Includes heat sink

Intel Pentium III processor – 500MHz (Katmai, 100MHz front side bus, 512KB Level-2 cache, Slot 1) – Includes heat sink for HP E60 PII/500

Intel Pentium III processor upgrade – Includes one 500MHz (Katmai, 100MHz front side bus, 512KB Level-2 cache, ECC) processor for HP E60 PIII/500

Intel Pentium III processor upgrade – Includes one 500MHz (Katmai, 100MHz front side bus, 512KB Level-2 cache, ECC) processor for HP E60 PIII/550

Intel Pentium III processor – 550MHz (Katmai, 100MHz front side bus, 512KB Level-2 cache, Slot 1) – Includes heat sink -for HP E60 PIII/550

Intel Pentium III processor – 600MHz (Katmai, 100MHz front side bus, 512KB Level-2 cache, Slot 1) – Requires processor fan accessory (D8595A)

Intel Pentium III processor upgrade – Includes one 600MHz (Katmai, 100MHz front side bus, 512KB Level-2 cache) processor for HP E60 PIII/600

Intel Pentium III processor – 550MHz (Katmai, 100MHz front side bus, 512KB Level-2 cache, Slot 1) – Includes heat sink – (Requires processor fan accessory, D8595A)

Intel Pentium III processor – 600MHz (Katmai, 100MHz front side bus, 512KB Level-2 cache, Slot 1) for HP E60 PIII/600